Lubrication; Corrective Action - Blackhawk Automotive BH7051 Instructions D'utilisation Et Manuel De Pièces

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NOTICE: Dispose of hydraulic fluid in accordance with local environmental regulations.
3. Set jack in its level position.
4. Perform Venting trapped air procedure (page 4).

Lubrication

1. A periodic coating of light lubricating oil to pivot points, axles and hinges will help to prevent rust and assure that
casters and pump assemblies move freely.
2. For air operated models BH7055: When used on a daily basis, air pump model should be internally lubricated
before each use. Use only good quality air tool lubricant. If no in-line oiler is used, pour a teaspoon of air tool oil
into the air supply inlet. Operate the jack using the air feature to fully distribute the oil.
Cleaning
Periodically check the pump piston and ram for signs of rust or corrosion. Clean as needed and wipe with an oily
cloth.
NOTICE: Do not use sandpaper or abrasive material on pump piston or ram surfaces.
Storage
When not in use, store the jack with saddle fully lowered.
TROUBLESHOOTING
Symptom
Jack will not lift load
Jack will lift, but not maintain
pressure
Jack will not lower after unloading
Poor lift performance
Jack will not lift to full extension
Fill reservoir with 2-1/2 quarts of premium hydraulic jack oil. Reinstall oil filler screw.
Possible Causes
• Load is too heavy
• Hydraulic unit malfunction
• Reservoir overfilled
• Fluid level low
• Hydraulic unit malfunction
• Fluid level low
• Consider higher capacity jack
• Discontinue use, Contact Black-
hawk Tech. Service
• Ensure load is removed, then drain
fluid to proper level
• Ensure proper fluid level
• Discontinue use, Contact
Blackhawk Tech. Service
• Ensure proper fluid level
5

Corrective Action

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Bh7055

Table des Matières