Instructions; Usage Without Wifi Connection - MILL SG1200 Wifi Mode D'emploi

6 6

Instructions

Control panel
See figure 6 on separate illustration sheet
1. Thermostat and WiFi button
A
2. Fan ON/OFF
3. ON/OFF button
WARNING!
INSTRUCTIONS BEFORE USING THE HEATER!
ATTENTION! Please be aware that when using the fan the temperature showing in the
app will be higher than the actual temperature in the room.

Usage without WiFi connection

1. Plug the heater into a grounded outlet.
2. Press the ON/OFF button.
3. Turn the thermostat to the desired temperature while looking at the display. As soon
as the room temperature drops below this level, the heater will automatically start
again. When the room has reached the desired temperature again, the heater will
turn itself o .
4. The thermostat goes from 5 to 35°C.
5. If you want to change the temperature in the room, repeat step 3.
6. Press the fan button to start the fan. Note that the fan is only active when the
heater is heating up (when the power indicator is on).
7. The heater has an overheat protection that turns the device o if any parts
become extremely hot.
8. If the temperature sensor is not functioning as it should,
the display. In such instances, the heater will switch itself o . Please contact your
distributor or importer.
9. To turn o the heater, press the ON/OFF button. Should the heater be le unused
for a longer period, pull out the plug.
BE SURE THE FOOT IS FITTED CORRECTLY AND ACCORDING TO THE
If the temperature sensor is not functioning properly, you will see this symbol
on the display. Please contact the dealer or importer.
1. Power indicator – shows whether the
B
heater is using power or not
2. Indicates whether the fan is activated
3. WiFi indicator
4. Desired room temperature
5. Thermostat and WiFi button
will be shown on