Installation; Installing/Replacing The Lamp; Danger To Life; Rigging - EuroLite Super Pinspot PAR-56 Mode D'emploi

Please consider that unauthorized modifications on the spot are forbidden due to safety reasons!
If this spot will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.

INSTALLATION

Installing/Replacing the lamp

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
Please follow the lamp manufacturer's notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need one 12 V/100 W PAR-56 lamp.
Procedure:
Step 1: Remove the frontcover from the housing.
Step 2: If replacing the lamp, remove the old lamp from the pinspot and loosen the wires.
Step 3: Loosen the screws on the new 12 V/100 W PAR-56 lamp with an appropriate screwdriver.
Step 4: Connect the cables of the pinspot via the cable lugs with the lamp.
Step 5: Tighten the screws.
Step 6: Insert the lamp in the housing.
Step 7: Fix the the frontcover on the housing.

Rigging

Please consider the EN 60598-2-17 and the respective national norms during the
installation! The installation must only be carried out by an authorized dealer!
The installation of the Pinspot has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.

DANGER TO LIFE!

Only install the lamp with the device switched off!
Disconnect from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
DANGER TO LIFE!
14/31 5080310A_V_2_2.DOC