Step 3. Connect The Cooktop To Gas Supply - Samsung NA30N6555T Serie Manuel D'installation

Installation instructions
Rubber
Smart connect module
Cover
Top view
Insert the wire connector
Wire connector
16 English
Install_NA30N6555TG_DG68-01091A-02_EN+MES+CFR.indb 16
1. Remove screws from all 5 burner cups
and 4 screws from the cooktop frame.
Remove the rubber protecting Smart
connect module. Pull out all knob dials
and lift up to remove the frame cooktop.
2. Detach Smart connect module from case
burner. Disconnect wire connector from
the PCB.
3. Install supplied cover in place of Smart
connect module.
4. Insert the wire connector diagonally into
the cover. Make sure it fits firmly.
5. Return all burner cups and cooktop frame

Step 3. Connect the cooktop to gas supply

Shut off the main gas supply valve before disconnecting the old cooktop and leave
it off until the new hookup has been completed. Don't forget to relight the burner
on other gas appliances when you turn the gas back on.
Because hard piping restricts movement of the cooktop, the use of a CSA
International-certified flexible metal appliance connector is recommended unless
local codes require a hard-piped connection.
WARNING
If the information in this manual is not followed exactly, a fire or explosion may
result, causing death, personal injury, or property damage.
– Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
– WHAT TO DO IF YOU SMELL GAS:
• DO NOT light a match, candle, or cigarette.
• DO NOT try to light any appliance.
• DO NOT touch any electrical switch.
• DO NOT use any phone in your building.
to original position, reinstall all knob
dials.
10/24/2018 4:29:19 PM