sylvac Power Manuel D'utilisation page 16

List of remote commands
This list shows the main remote commands applied with Power, RS232 and USB cable used with «Duplex»
instruments. Refer to the instructions for use of the instrument for the specific command.
<NOR>
<MOD?>
<STO0>, <STO1>
<RST>
<SET?>
<ID?>
<OUT0>, <OUT1>
<OFF>
<ON>
<PRI>, <?>
<MM>, <IN>
<RES2>, <RES3>
<REF1>, <REF2>
<PRE>
<PRE?>
<PRE +123.45>
<PRE +0>
Resets the instrument into measuring mode (or into reference mode if the keyboard
is disabled)
The instrument sends its operating mode (NOR, REF , MIN, MAX, DEL, TOL1)
Disables, enables measuring value hold
Resets the instrument to its initial parameters
The instrument sends its main parameters: (MM RES2 REF1 etc) Note: B1 battery OK
, B0 replace the battery
The instrument sends its identification code:
Disables, enables continuous transfer of the displayed value
Switches OFF the instrument
Switches ON the instrument
The instrument sends the displayed value. Note: in tolerance mode, the value is
followed by the symbols '<', '=' or '>'.
Changes the measurement unit
Changes the resolution: <RES2>: 0.001 mm, <RES3>: 0.01 mm
Changes the reference
Recalls the preset
The instrument sends the preset value of the active reference
Enter preset value. Numerical values must always be preceded by a sign.
16
E