Dryer Motor Assembly - Bradley Verge LVQ Serie Manuel D'installation

LVQD1
9

Dryer Motor Assembly

CAUTION If dryer motor is not secured properly
to flexible PVC dryer tube, motor may
come lose and detach from tube.
Slide the hose clamp onto
A
the flexible PVC dryer tube
and begin to tighten clamp
so that it does not fall off.
While holding the motor
from the bottom with one
B
hand, insert dryer outlet
nozzle into the flexible
PVC dryer tube.
Tighten hose clamp using
C
the 5/16" socket wrench.
Tighten clamp to 30-35
in/lbs.
Check to be sure motor
is securely attached to
D
flexible PVC dryer tube
by gently pulling down on
motor. Motor should stay
attached to tube.
After assembly, dryer
motor should hang freely.
E
Secure dryer motor foam
bumper to finished wall,
in-line with the dryer motor
feet.
Bundle loose cords to
F
motor using hook and loop
cable tie.
Discard water detector
G
wire (shipped loose) and
RJ45 connector cable
from motor and discard.
Water Detector
Wire
14 2/4/2019
Hose Clamp
Front View of Motor
Power Cord to GFCI Outlet
Power Cord to DC Adapter Only
Bradley • 215-1842 Rev. E; ECO 18-08-023
Flexible Hose
Dryer Outlet Nozzle
Dryer Motor
Foam Bumper
Dryer Motor Feet
RJ45 Connector Cable
(unplug and discard)
Dryer Motor, 120V/60Hz
Installation