Closing The Housing - Niko 10-491-01 Mode D'emploi

5.5. Setting the dome camera
▶ Aim the dome camera towards the location to
be guarded using the relevant setting screws.
▶ View the video image on a monitor.

5.6. Closing the housing

▶ Place the connection on the housing ring.
▶ Tighten the hexagonal screws using the hexagonal key.
CAUTION! People could get hurt if the camera falls.
Ensure that the housing ring, dome and camera holder are securely in place.
6. MOUNTING AND CONNECTION OF TWO-WIRE VIDEO TRANSMITTER (10-498)
6.1. Overall picture of the device
3
EN
Settings screws for zoom and focus
Setting screws (always opposite
one another) to turn the camera
head (360°C)
Setting screws (always opposite
one another) to swivel and tilt
the camera
Setting screw to turn the base
of the camera (360°C)
Image 4: Setting of the dome camera
4 5
V2 V1 M P b a
Video
OUT
Video IN Camera
V 12V
2 1
Image 5: Overall picture of the device
Connection terminals camera power supply
Connection terminals video input (coax)
Control button for brightness
Connection terminals videoo
Connection terminals bus
10-491-01
37