ims PRO TIG PRO 201 AC/DC Notice Originale page 24

Translation of the original instructions
HUMAN-MACHINE INTERFACE (HMI)
The figure below shows the HMI of the TIG PRO 201 AC/DC and TIG PRO 201L AC/DC.
Sleep Mode /
Sleep Exit
Up current
button
Pre-gas
button
Processes
Functions
Sleep Mode /
Sleep Exit
Sub-processes
AC/DC
AC
A/V display
selection
JOB
24
TIG PRO 201 AC/DC - TIG PRO 201L AC/DC
Cold current
A/V display
button
Display selection
Courant de
soudage
Pulse
Trigger
Frequency
mode
Button
Pictograms MMA
•
•
•
•
Creating /
Recalling /
Deleting JOBS
TIG AC
Evanouisseur
Sub-processes AC / DC
TIG DC TIG AC Comments
Button to put the product into and out of sleep
• •
mode.
In MMA process: access to "Pulse MMA"mode,
In TIG DC: access the "Pulse" or "Spot " modes.
•
Choose between TIG "DC", TIG "AC" and TIG
• •
"AC - Easy".
Select the parameter to be adjusted between
•
"Frequency" and "Balance".
At the end of a welding cycle, the welding cur-
rent is shown on the display. Pressing this button
• •
switches between the display of this current and
the display of the welding voltage.
Allows you to recall, create and delete a job.
Refer to the JOB section for more information.
• •
Post gas
button
AC
EN