Switching Off - Kampa Geyser Instructions De Montage Et De Service

1. Submerge the pump in a suitable reservoir of
clean water (see fig. 8, page 6).
2. Move the water outlet tap (fig. 2 6, page 3)
in the desired position.
3. Place a suitable water container under the
water outlet tap.
4. Ensure that the water flow regulation switch
(fig. 2 11, page 3) is in the "open" position.
A
NOTICE!
Make sure to move the shower head
away from the water heater so that no
water gets spilled onto the appliance.
5. For use of the shower head:
Move the shower head in the desired position.
Ensure that the water flow regulation switch
(fig. 2 11, page 3) is in the "open" position.
Slide the shower head switch to the "ON"
position (fig. 9, page 6).
6. Check that all connections are tight.
7. Turn the gas regulator valve on.
8. Turn the power switch (fig. 2 10, page 3) to
the "ON" position.
✔ Water should start to flow from the shower head
or water outlet tap within 20 seconds, then the
electronic ignition should be heard igniting the
burner.
9. Make sure the burner flame is operating by
watching through the burner viewing window
(fig. 2 4, page 3) on the appliance.
!
CAUTION! Burn hazard
Check the water temperature before
using the water. The outlet water can
reach temperatures of 50 °C.
10. If necessary, adjust the water temperature by
turning the temperature control knob
(fig. 2 2, page 3) from the minimum to maxi-
mum heat position to reach the desired heat
level.
11. In the event that the temperature lift is insuffi-
cient, simply run water through the appliance
once, returning the heated water to the source
water reservoir, then run again through the
appliance until the desired temperature is
reached.
14
Stopping the water flow
➤Close the water flow regulation switch
(fig. 2 11, page 3).
For use of the shower head:
➤Stop the water flow by sliding the shower head
switch to the "OFF" position (fig. 0, page 6)
and by closing the water flow regulation switch
(fig. 2 11, page 3).
Continuing the water flow
!
CAUTION! Burn hazard
Water remaining in the heater exchanger
while the flow is stopped may become
hot. Check the water temperature before
using the water.
➤Open the water flow regulation switch
(fig. 2 11, page 3).
➤For use of the shower head:
Slide the shower head switch to the "ON" posi-
tion (fig. 0, page 6)
✔ Water will commence to flow and the burner will
reignite within 5 seconds.

Switching off

1. Stop the water flow (see chapter "Stopping
the water flow" on page 14).
2. Turn the power switch (fig. 2 10, page 3) to
the "OFF" position.
3. Turn off the gas supply at the gas cylinder after
use.
Disconnecting the water heater from
the gas cylinder
1. Check that the appliance is fully extinguished,
the gas regulator is in the "OFF" position and
all surfaces are cool.
2. Follow the instructions of the gas regulator
manufacturer to disconnect the gas regulator
from the gas cylinder.
4445103340