Cleaning And Maintenance; Storing The Water Heater; Troubleshooting - Kampa Geyser Instructions De Montage Et De Service

Cleaning and maintenance

A
NOTICE!
• Never clean the appliance under run-
ning water or in dish water.
• Do not allow water to enter the burner
outlets, mantle or aeration holes
located in the base of the burner tube.
• Do not use sharp or hard objects, abra-
sive cleaning agents or bleach during
cleaning as these can damage the
appliance.
➤Occasionally clean the appliance exterior with a
mild detergent and a damp cloth.

Storing the water heater

1. With the appliance operating, turn the gas
regulator off.
✔ The burner will continue to operate until all gas
has bled from the gas hose and gas regulator
assembly.
2. Turn the power switch (fig. 2 10, page 3) to
the "OFF" position.

Troubleshooting

Fault
Water will not flow from
shower head.
Burner will not light.
Possible cause
The appliance is switched off.
Water supply is insufficient.
The water pump is not connected to the
appliance.
DC power supply is not adequate.
The shower head switch is in "OFF"
position.
Water is not flowing from the shower head. Turn the shower head switch to "ON"
The inlet water is over +50 °C warm.
The gas cylinder is turned off.
There is no gas in the gas cylinder.
3. Disconnect the water pump from the appli-
ance (see fig. a, page 7) and allow all water
to drain out (fig. b, page 7).
4. Disconnect the shower head and water hose
from the water outlet (see fig. c, page 7) and
allow all water to drain out (fig. d, page 7).
5. Disconnect the 12 V DC cable (see fig. e,
page 8).
6. Disconnect the gas hose from the appliance
(see fig. f, page 8).
7. Disconnect the gas hose from the gas regula-
tor (see fig. g, page 9).
8. Follow the instructions of the gas regulator
manufacturer to disconnect the gas regulator
from the gas cylinder.
9. Leave the appliance to cool down properly.
10. Store the appliance and its parts in the carry
bag.
11. Place the carry bag in a dry and well ventilated
area free from direct sunlight, heat and ignition
sources.
4445103340
Solution
Switch on the appliance.
Provide sufficient water supply.
Connect the water pump to the appliance.
Provide adequate DC power supply.
Turn the shower head switch to "ON"
position.
position.
Let the inlet water cool down below
+50 °C.
Turn the gas cylinder on.
Exchange the gas cylinder.
15