Braun ScoutingCam BLACK800 Mode D'emploi page 34

2. Normal working mode
In this mode, shooting is triggered by the sensor. Enter the monitor mode by
switching to "ON" position, and the LED will go out after 5 seconds. The
camera starts to operate independently and enters standby mode. Once an
animal enters the detection area detected by the secondary sensor, the
camera will be activated and motion will be detected. If the object continues
to move to the area detected by the main sensor, the camera will
automatically take a picture or video. If the animal leaves the area detected
by the sensor, the camera will turn off and return to standby state.
3. Night working mode
3.1 During night the infrared LEDs on the front of the camera provide the
required light for taking pictures. The LEDs make the camera to shoot
pictures within 3m-20m.However, reflective objects can cause
overexposure.
3.2 Please note that pictures taken in night are black and white. When
recording a video for a long time, the low voltage may have great
influence on the stability of the camera. So in case of the low voltage, it
better not to record in the evening.
14