NOSTALGIA PRODUCTS CCP610 Instructions Et Recettes page 10

Assembly of Wheels
1. Put #4 Flat Washer onto Axle Bolt (F) and insert into Base Support (I).
2. Put on #4 Flat Washer. Slide Wheel (G) onto Axle Bolt (F), then add a
second #4 Flat Washer, a #3 Spring Washer, and #6 Nut Cap.
3. Use Wrench (H) to tighten the #6 Nut Cap.
4. On the other side of Base Support (I), insert second Axle Bolt (F) with #4 Flat Washer, add #4
Flat Washer, second Wheel (G), another #4 Flat Washer, a #3 Spring Washer, and a #6 Nut Cap.
5. Use Wrench (H) to tighten the #6 Nut Cap.
#4 Flat
Washer
#6
Nut
Cap
#3 Spring
Washer
Assembly of Main Unit
1. Place Main Unit (A) onto the top of the Concession Stand (C).
2. Ensure that the two inserting pins at the bottom of the Main Unit (A) line up correctly
so that Main Unit (A) can be locked under the beam of the Concession Stand (C).
#4 Flat
Washer
(F) Axle
Bolt
(G) Wheel
(I) Base
8