Optional Accessories - Makita CV101D Manuel D'instructions

Indicator lamps
Lighted Off
NOTE:
• Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from the
actual capacity.
ASSEMBLY
CAUTION:
• Hold the battery holder and the battery cartridge
firmly when installing or removing battery
cartridge. Failure to hold the battery holder and the
battery cartridge firmly may cause them to slip off your
hands and result in damage to the battery holder and
battery cartridge and a personal injury.
Installing or removing battery cartridge to
the battery holder (Fig. 3)
To install the battery cartridge (10), align the tongue on
the battery cartridge with the groove in the battery holder
and slip it into place. Insert it all the way until it locks in
place with a little click. If you can see the red indicator (9)
on the upper side of the button, it is not locked completely.
Always install the battery cartridge fully until the red
indicator cannot be seen. If not, it may accidentally fall out
of the battery holder, causing injury to you or someone
around you.
Do not install the battery cartridge forcibly. If the cartridge
does not slide in easily, it is not being inserted correctly.
To remove the battery cartridge, slide it from the battery
holder while sliding the button (8) on the front of the
cartridge.
Attaching the battery holder to the heated
vest (Fig. 4)
You can either place the battery holder in the battery
holder pocket or hang on the belt.
In case placing it in the pocket, connect the battery holder
and the power cable of the jacket and place it in the
battery holder pocket.
In case hanging it on the belt, firstly pass the jacket's plug
through the hole inside the battery holder pocket, and
connect the battery holder and the power cable of the
jacket. And then hang the battery holder on your belt.
Connecting USB device (Fig. 5)
CAUTION:
• Connect only devices which are compatible with DC5V,
2.1A power source to the USB power supply port.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Otherwise it may cause malfunction to the battery
holder.
The battery holder (with the battery) can work as an
external power supply for USB device. Connect the USB
cable (not included) with the power supply port of the
battery holder. And then connect the other end of the
cable with the device. Turn on the switch next to the USB
port. The USB cable can be placed inside the vest for
convenience by using the hole of the pocket and cable
holder.
NOTE:
• Before connecting USB device to the charger, always
backup your data of USB device. Otherwise your data
may lose by any possibility.
• The charger may not supply power to some USB
devices.
• When not using or after charging, remove the USB
cable and close the cover.
• The battery power is consumed while the switch next to
the USB port is turned on. Always turn off the switch
when not in use.
MAINTENANCE
CAUTION:
Never use gasoline, benzine, thinner, alcohol or the like.
Discoloration, deformation or cracks may result.
CAUTION:
Always be sure that the vest is switched off and the
battery cartridge is removed before attempting to perform
inspection or maintenance.
If vest does not switch on or any fault is found with a fully
charged battery cartridge, clean the terminals of the
battery holder and the battery cartridge. If vest still does
not work properly, stop using the vest and contact our
authorized service center.

OPTIONAL ACCESSORIES

CAUTION:
These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
package as standard accessories. They may differ from
country to country.
5