G Operating instruction
Controls and Displays
1
MODE selection button
2
Two-wheeler mode (12 V/0.9 A)
3
Car mode (12 V/4.0 A)
Old-timer on-board power supply mode
4
(6 V/4.0 A)
Mode for charging in low ambient
5
temperatures (6 V or 12 V)
Lithium mode
6
(12.8-V 4-cell LiFePO4/3.0 A)
7
Mode for battery recovery (12 V/4.0 A)
A
Battery charging status indicator
VOLT: current voltage of the connected
B
battery
AMP: current charging current
C
according to selected mode
D
Flashing: no battery connected
Value of the current charging voltage/
E
charging current
Fault symbol: battery chemically defective
F
('dead')
Flashing: battery connected with polarity
G
reversed
Thank you for choosing a Hama product.
Take your time and read the following instructions and infor-
mation completely. Please keep these instructions in a safe
place for future reference. If you sell the device, please pass
these operating instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Risk of electric shock
This symbol indicates product parts energized with a
dangerous voltage of sufficient magnitude to constitute a
risk of electric shock.
Warning
This symbol is used to indicate safety instructions or to draw
your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2
2. Package Contents
• Automatic battery charger
• These operating instructions
3. Safety Notes
• This product is not intended for use by persons, including
children, with limited physical, sensory or mental abilities
or lacking in experience or knowledge, unless they are
supervised by a person responsible for their safety or have
been instructed on how to use the product.
• Children are not permitted to play with the device. Children
may not clean the product or perform user maintenance
without supervision.
• Protect the product from dirt, moisture and overheating, and
only use it in a dry environment.
• Do not drop the product and do not expose it to any major
shocks.
• Do not operate the product outside the power limits given in
the specifications.
• Lay all cables so that they do not pose a tripping hazard.
• Do not bend or crush the cable.
• Do not cover the product – there is a risk of overheating.
• Keep the packaging material out of the reach of children due
to the risk of suffocation.
• Do not modify the product in any way. Doing so voids the
warranty.
• This product is intended for private, non-commercial use
only.
• Use the product for its intended purpose only.
• Do not use the product in the immediate vicinity of heaters
or other heat sources or in direct sunlight.
• Use the item only in moderate climatic conditions.
• Keep this product, as all electrical products, out of the reach
of children!
• Do not use the product in areas where the use of electronic
devices is not permitted.
• Do not use the product in moist environments and avoid
splashes.
• The product may only be operated with the type of power
supply network described on the name plate.
Warning – Batteries
• When inserting batteries, note the correct polarity (+ and
- markings) and insert the batteries accordingly. Failure to
do so could result in the batteries leaking or exploding.
• Only use batteries (or rechargeable batteries) that match
the specified type.
• Before you insert the batteries, clean the battery contacts
and the polar contacts.
• Do not allow children to change batteries without
supervision.
• Do not mix old and new batteries or batteries of a different
type or make.
• Remove the batteries from products that are not being
used for an extended period (unless these are being kept
ready for an emergency).
• Do not short-circuit batteries.