Operation; Main Unit Operation; Auto Operation; Silent Operation - Sharp FU-60SE Manuel D'utilisation

OPERATION

MAIN UNIT OPERATION

The unit will start operation when the MODE/
The unit will start operation in AUTO operation (fan level).
• During operation, the cluster ion lamp will be lit.
The operation mode is switched as follows every time the button is pressed.
The lamp for the operation mode that has been set is lit.
The operation mode suited to the usage condition can be set.

Auto operation

The fan level is automatically
switched (High, Medium, Si-
lent) depending on the amount
of pollution in the air detected
by the sensor for efficient air
purification.

Silent operation

The unit will operate quietly
using minimal air intake.
For the first 30 seconds after the power plug is in-
serted into the wall outlet, the unit will check the con-
dition of the air. If operation is set to ON during this
time, the CLEAN-SIGN lamp will alternately flash
green, orange and red.
Cluster ion lamp
Plasmacluster
MODE/
button is pressed.
Stop
Pollen mode Operation
The unit will operate at High level for
10 minutes, then will alternate be-
tween Medium and High.
10 minutes: High fan level
20 minutes: Medium fan level
20 minutes: High fan level
Medium to Max operation
The unit will operate at a fan level of
medium, high or max.
E-10
Operations available with main unit
• AUTO operation (fan level)
• Silent operation (fan level)
• Medium operation (fan level)
• High operation (fan level)
• Max operation (fan level)
• Pollen mode operation
button