Accessories; Switching Off The Machine; Maintenance Operations - Lavor GV 1,8 M PLUS Mode D'emploi

ACCESSORIES

Put the gun plug in the special socket then block it
by means of the two levers;
CONNECTION TO FLEXIBLE HOSE:
- Open hatch A, insert the rapid snapon
attachment B of the flexible hose into the
machine connection, and push in as far as
possible.
- To disconnect the flexible hose, open hatch
A, press the release button C and extract the
hose.
STARTING UP AND OPERATING THE
MACHINE
1) Check the level of the water and detergent
tanks. If necessary, fill these tanks.
2) Connect the supply cable to the main line so-
cket.
3) Turn main switch (1) to ON position.
4) Wait for the green HEATING light (E) to turn itself
off and make sure the gauge (5) shows a pressu-
re reading of 9 bar.
At this point, the machine is ready for operation.
5) To discharge the detergent, press the SOAP ON
button (I).
Or: press the SOAP ON button (J) to top gun.

SWITCHING OFF THE MACHINE

1) Press ENABLE DRAIN button (K) to disable the
resistances and water pump.
2) Using the pistol, allow all the steam in the boiler
3) Turn the main switch (1) to the OFF position.

MAINTENANCE OPERATIONS

EMPTYING OUT THE BOILER
The stainless steel boiler presents specifications
which enable its use with normal water. As a
rule, once a week, or if the machine is not being
operated, empty out the boiler using the spe-
cial tap B.
It is very important to clean the hoses and boiler
thoroughly to prevent lime from forming.
To eliminate this problem, please follow these fun-
damental instructions:
- never leave the machine switched when not in
use. Switch off the machine main switch when it
is not in use.
M M
16
J
B
M M