Adjusting The Harness - R82 Wallaroo Guide D'utilisation

10. The chest pads may be placed in any
position that is comfortable for the child,
within the range of the correctly placed
chest clip.
EN
11.
Verify that harness is not twisted and child
is properly secured.
See Safety Information on page 6
WARNING! Chest pads must be used at
all times.
IMPORTANT:
•
Always pull on the harness after securing the
child to ensure the buckle tongues are secure in
the harness buckle. If the buckle will not fasten
with an audible click after insertion of each
buckle tongue, the harness buckle or adjuster
area may be clogged with debris that needs to
be removed. See cleaning instructions.
• Adjust the belts provided with the child
restraint so they fit snugly around your child. A
snug strap should not allow any slack. It lies in
a relatively straight line without sagging. It does
not press on the child's flesh or push the child's
body into an unnatural position.
A
B
SECURING YOUR CHILD

Adjusting the Harness

Loosen the harness by lifting the harness
1.
adjuster lever while pulling the shoulder
straps forward as far as possible (Fig. A).
From the rear of the child restraint, unhook
2.
the shoulder harness straps from the yoke
(Fig. B).
Pull the harness straps through the shell,
3.
foam and cover to the front of the child re-
straint.
Thread the harness straps through the ap-
4.
propriate harness slots in the cover, foam
and seat shell (Fig. C+D).
Reattach the harness straps to the harness
5.
yoke.
Pull harness adjuster strap to tighten the
6.
harness.
Verify that all straps are threaded at the same
height and are not twisted.
C
D
28
support.R82.org