Installation For Children 10.1-23 Kg (22.2-50 Lbs.) Us And Canada; Lap-Shoulder Belt - Short Route - Single Tether - R82 Wallaroo Guide D'utilisation

INSTALLATION FOR CHILDREN 10.1-23 kg (22.2-50 lbs.) US and Canada

Lap-Shoulder Belt - Short Route - Single
Tether
You must always use the top tether when
installing this child restraint. Loosen the tether
strap and place it up and over the child restraint
back (A).
WARNING!
•
Occupant under 13.6kg (30 lbs) MUST use
recline wedge
Installation
Place the child restraint in the forward-facing
position on the vehicle seat. Ensure the bottom
of the child restraint shell is in full contact with
the vehicle seat.
Pull the vehicle belt out and route through the
belt slot furthest from the vehicle buckle (B),
from the rear to the front of the child restraint.
Route the vehicle belt under the child restraint
cover, between the comfort foam and the child
restraint shell, and through the belt slot (C)
closest to the vehicle buckle from front to rear of
the child restraint.
Verify that the vehicle belt is not twisted and
then buckle.
support.R82.org
Push the child restraint firmly into the vehicle
seat while removing slack, first from the lap
portion and then from the shoulder portion of
the vehicle belt.
Lock the vehicle belt according to the
instructions in your vehicle owner's manual.
Attach the tether hook to the vehicle-designated
tether anchor for the chosen seating position
(D). Remove all slack from the tether to secure
(E). Store any excess tether strap webbing within
your vehicle.
Verify that all connections are secure, the
vehicle belt is tight, and the child restraint is
secure.
NOTE: The child restraint is secure when it
cannot be moved more than 2,5 cm (1 inch)
front-to-back or side-to-side at the belt path.
If the child restraint is not secure, repeat this
procedure or use an alternate seating position.
C
E A
D
B
13
EN