Installation For Children 23-28 Kg (50-62 Lbs.) Us And Canada; Lap-Shoulder Belt - Short Route - Dual Tether - R82 Wallaroo Guide D'utilisation

INSTALLATION FOR CHILDREN 23-28 kg (50-62 LBS.) US AND CANADA

Lap-shoulder belt - Short Route - Dual Tether

You must always use the top tether hooks when
installing this child restraint. Loosen the tether
strap and place it up and over the child restraint
EN
back (A).
Intallation
Place the child restraint in the forward-facing
position on the vehicle seat. Ensure the bottom
of the child restraint shell is in full contact with
the vehicle seat
Pull the vehicle belt out and route through the
belt slot furthest from the vehicle buckle, from
the rear to the front of the child restraint (B).
Route the vehicle belt under the child restraint
cover, between the comfort foam and the child
restraint shell (C), and through the belt slot
closest to the vehicle buckle from front to rear of
the child restraint.
Verify that the vehicle belt is not twisted and
then buckle.
Push the child restraint firmly into the vehicle
seat while removing slack first from the lap
portion and then from the shoulder portion of
the vehicle belt.
Lock the vehicle belt according to the
instructions in your vehicle owner's manual.
Attach both tether hooks to the vehicle
designated tether anchors for the chosen
seating position (D). Remove all slack from the
tether to secure (E). Store any excess tether
strap webbing within your vehicle.
Verify that all connections are secure, the
vehicle belt is tight, and the child restraint is
secure.
NOTE: The child restraint is secure when it
cannot be moved more than 2,5 cm (1 inch)
front-to-back or side-to-side at the belt path.
If the child restraint is not secure, repeat this
procedure or use an alternate seating position.
C
E A
D
B
support.R82.org
16