Hama 179809 Mode D'emploi page 12

6.4 CLEARING OF LEARNED KEYS
6.4.1 CLEARING OF ONE LEARNED KEY
1. Press and hold [MUTE] and [VOL+] keys for 3 seconds until the LED will
be lit.
2. Enter the code [9] [8] [1], the LED will flash 2 times and then remain on.
3. Press and release the desired key at the replacement remote control which
you want to clear the learned command. If the LED flashes 3 times, the
learned command has been cleared successfully.
6.4.2 6.4.2 CLEARING OF ALL LEARNED KEYS
1. Press and hold [MUTE] and [VOL+] keys for 3 seconds until the LED will
be lit.
2. Enter the code [9] [8] [2], the LED will flash 2 times and then remain on.
3. Press and release the [OK] key at the replacement remote control. If the LED
flashes 3 times, all commands have been cleared successfully.
7. EASY Mode
This remote control is equipped with an EASY Mode. Thus you could reduce
the functionality of the remote control to its basic functions. It avoids that the
TV Settings are changed by mistake.
During the EASY Mode you still could use following keys:
Switch the TV On or Off
Change the volume
Mute the TV
Change the program
0-9 Numeric keys for program selection/ direct page selection Teletext
TXT Teletext ON/OFF
Select On-Screen Options
EPG Show the Electronic Program Guide
(if supported by the TV)
Select signal source
EXIT Exit Menu
7.1 Enter EASY Mode
1. Press and hold [MUTE] and [SHARE SCREEN] keys for 3 seconds until the
LED will be lit.
2. Enter the code [9] [7] [0], the LED will flash two times and then remain on.
3. Press and release the [OK] key, if LED flash 3 times, you have entered the
EASY Mode successfully.
7.2 Exit EASY Mode
1. Press and hold [MUTE] and [SHARE SCREEN] for 3 seconds until the LED
will be lit.
2. Enter the code [9] [7] [0], the LED will flash two times and then remain on.
3. Press and release the [EXIT] key, if LED flash 3 times, you have exit the
EASY Mode.
Note
• While the EASY Mode is activated only the keys mentioned in chapter 7.
will work. If one of these keys is pressed the LED will be lit until the key is
released. If one key is pressed during the normal mode, the LED will flash.
10