Direct Code Entry; Manual Code Search - Hama 179809 Mode D'emploi

Warning
• Do not allow children to change batteries without supervision.
• Remove the batteries from products that are not being used for an
extended period.
4. Getting started – installing the Batteries
Note
• Use 2 AAA batteries
• Remove the battery cover from bottom of remote (Pic. A).
• Check the +/- polarity on the batteries and inside the compartment.
• Insert the batteries (Pic. B).
• Slide the battery holder back into the remote until the clips locate (Pic. C).
Note – Code Memory
• This remote control saves the settings during battery change.
5. Setup
This remote control can by default control 90% models of GRUNDIG brand,
there´s no need to set it up. lf it doesn't work, please choose one of the follow-
ing setup methods 5.1 or 5.2.

5.1 DIRECT CODE ENTRY

CODE List:
001, 002, 003, 004, 005, 006, 007, 008, 009, 010, 011, 012, 013, 014,
015, 016, 017, 018, 019, 020, 021, 022, 023, 024, 025, 026, 027, 028,
029, 030, 031, 032, 033, 034, 035, 036, 037, 038, 039, 040, 041, 042,
043, 044, 045, 046, 047, 048, 049, 050, 051, 052, 053, 054
1. Press and hold the [MUTE] & [POWER] keys for approx. 3 seconds until the
LED will be lit.
2. Enter the corresponding 3-digit codes from code list using the digit keys.
The LED indicator confirms each entered digit by a short flash and turns off
after 3 valid digits. Otherwise, the LED will flash
3 times and then remain on for re-entry.
3. Please try to use the remote control.
lf it doesn't work well, please try other codes: [002], [003], [004] ...
Note
• No entry for approx. 15 seconds will time out the set-up mode.
• If the code is invalid, the LED flashes 3 times and then lights up perma-
nently.
• To exit the setup, please press the [MUTE] key.

5.2 MANUAL CODE SEARCH

1. Press and hold [MUTE] and [POWER] keys for approx. 3 seconds until
the LED will be lit.
2. Press and release [P+] or [P-] key to start searching the code. Each time
you press, the remote will change to the next code.
3. Please test if the [POWER], [VOL+], [MENU], [0-9] keys work well. If ok,
please press the [MUTE] key to save the code and exit.
4. If it doesn't work well, repeat the fast search by pressing the [P+] or
[P-] key.
Note
• At the set-up mode, only the [POWER], [VOL+], [MENU], [0-9] keys are
working.
8