Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Set Up: SOURCE-CAM1, SOURCE-CAM2, SOURCE-CAM3, SOURCE-CAM4 options will display on the screen as illustrated below :
•
Press
to select SOURCE-CAM1 to SOURCE-CAM4
SET UP
SOURCE-CAM1
SOURCE-CAM2
SOURCE-CAM3
SOURCE-CAM4
Press - / + to select ON / OFF
Troubleshooting:
The symptoms described below do not necessarily mean a failure within the display. Please check the following items before you initiate
request for repair.
Symptoms
No picture, no sound
No picture
No sound
Dark picture
No color
Upside down or lateral inverted picture
No reversing function (i.e.Picture)
Declaration of conformity:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
920-5203-00 Rev. D
ON
ON
ON
ON
Improper connection of automobile adapter. Use of un-authorized power supply. Power switch
is on OFF position.
Check whether AV cable is properly connected
Check whether audio wire is properly connected or the sound volume is turned off or set too
low.
Check whether brightness and contrast are adjusted correctly; Check whether the
environments temperature is too low.
Adjust the color settings.
Use the remote control horizontal /vertical selection switch to set proper orientation
The black wire of the monitor AV cable to the reversing light may be loose. The red wire from
the monitor may be loose.
SET UP
SOURCE-CAM1
SOURCE-CAM2
SOURCE-CAM3
SOURCE-CAM4
E.g. Press
to select SOURCE-CAM4 and press - / + to select OFF. CAM4
will be shut off. Press "S" to switch channels, CAM4 will not be displayed on the
screen.
Possible Causes/Solutions
ON
ON
ON
OFF
Page 11 of 12
Publicité
Table des Matières
