Metal Marks And Scratches; Damage From Sugary Spills And Melted Plastic - Cafe CEP7030 Manuel Du Propriétaire

Cleaning the Glass Cooktop (Cont.)

Metal Marks and Scratches

cooktop. It will leave metal markings on the cooktop
surface.
These marks are removable using the CERAMA
Ceramic Cooktop Cleaner with the CERAMA
®
Cleaning Pad for Ceramic Cooktops.
®

Damage from Sugary Spills and Melted Plastic

Special care should be taken when removing hot substances to avoid permanent damage of the glass surface.
Sugary spillovers (such as jellies, fudge, candy, syrups) or melted plastics can cause pitting of the surface of your
cooktop (not covered by the warranty) unless the spill is removed while still hot. Special care should be taken when
removing hot substances.
1. Turn off all surface units. Remove hot pans.
2. Wearing an oven mitt:
the spill to a cool area on the cooktop.
b. Remove the spill with paper towels.
Cleaning Trim
Do not use a steel wool or green pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy water or a stainless steel cleaner or polish. Always wipe the
surface in the direction of the grain. Follow the cleaner instructions for cleaning the stainless steel surface. To inquire
about purchasing stainless steel appliance cleaner or polish, or to find the location of a dealer nearest you, visit
cafeappliances.com.
Cleaning Knobs
The control knobs may be removed for easier cleaning.
Make sure the knobs are in the Off positions and pull
them straight off the stems for cleaning. The knobs can
be cleaned in a dishwasher or they may also be washed
with soap and water. Make sure the insides of the knobs
are dry before replacing. Replace the knobs in the Off
position to ensure proper placement.
49-80832
2. If pots with a thin overlay of aluminum or copper
are allowed to boil dry, the overlay may leave black
discoloration on the cooktop.
This should be removed immediately before heating
again or the discoloration may be permanent.
NOTE: Carefully check the bottom of pans for roughness
that would scratch the cooktop.
3. Any remaining spillover should be left until the surface
of the cooktop has cooled.
residue has been completely removed.
NOTE: If pitting or indentation in the glass surface has
already occurred, the cooktop glass will have to be
replaced. In this case, service will be necessary.
Molded rib
Stem
Clear groove
Spring
clip
13