Introduction - Oce VARIOPRINT 5000 Stacker Manuel Opérateur

Welcome to the Océ VP 5000 Stacker. This product is a finishing option available on the Océ
VP 5000 Series Printer.
The stacker has a nominal capacity of approximately 5000 sheets, can handle all Printer
paper weights and sizes and can provide a 15 mm (.6 in.) offset for each set.
The Océ VP 5000 Stacker will enable in-line finishing by receiving sheets from the host
printer and compiling these sheets into a stack. Océ VP 5000 Stacker units can be installed in
tandem.
The stacks accumulate on one of two wheeled carts supplied in the stacker, allowing you to
move the stack to the next step in the work process while filling the second cart.
Additionally, the stacker has a bypass path allowing another finishing choice to be attached to
the system at the same time. Thus you can alternate jobs between stackers and another device.
The information contained in this manual is based on the most current information available at
the time of editing.
Note: This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC (Federal
Communications Commission) Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordan-
ce with the instruction manual, may cause harmful interference to radio com-
munications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Canadian Department of Communications Compliance Statement:
This equipment does not exceed Class A limits per radio noise emissions for digital apparatus
set out in the Radio Interference Regulation of the Canadian Department of Communications.
Operator Manual
Page 9 - 5

INTRODUCTION

Initial issue: 01/03
Latest revision: