Oce VARIOPRINT 5000 Stacker Manuel Opérateur page 19

2.LED: no function.
3.LED is on when a jam was detected by paper path sensor in input baffle (A).
This means:
- Either there is paper blocked under baffle (A) sensor or
- A sheet came under baffle (A) sensor but was not supposed to.
- A sheet was announced by previous stacker but no sheet came or the sheet came too late
4.LED is on when a jam was detected by paper path sensor on lower transport baffle(C).
This means:
- Either there is paper blocked under baffle (C) sensor or
- A sheet was detected by input sensor baffle (A) and was supposed to go to lower
registration table via baffle (C) and did not make it (or did not make it in time) or
- A sheet came under baffle (C) sensor but was not supposed to.
5.LED is on when a jam was detected by paper path sensor on exit baffle (E).
This means:
- A sheet was detected by input sensor (baffle A) and was supposed to go to bypass exit
baffle (E) and did not make it (or did not make it in time) or
- A sheet came at the output but was not supposed to.
6.LED is on when a jam was detected by paper path sensor on stacking path baffle (F).
This means:
- Either there is paper blocked under baffle (F) sensor or
- A sheet was detected by input sensor baffle (A) and was supposed to go via upper
registration table to stacking path baffle (F) and did not make it (or did not make it in
time) or
- A sheet was detected by lower registration path sensor on baffle (C) and was supposed
to go to stacking path baffle (F) and did not make it (or did not make it in time) or a
sheet came under baffle (F) sensor but was not supposed to.
Having more than one LED on means that besides the primary jam cause, there is paper in
front of other paper path sensors.
Operator Manual
Page 9 - 19
JAM DETECTION
Initial issue: 01/03
Latest revision: