Declaration Of Conformity - SIOUX A Serie Manuel D'instructions Et Pièces Détachées

Changing Heads.
1. Add a nut or short screw to the head assembly to retain the internal parts.
2. Loosen and remove the ring SDR-91.
3. Remove the head assembly and the hex drive bit.
4. Install the new head assembly making sure the hex bit is seated in the drive spindle and the fastener head. Remember that all stud-type tools use
the same bit, but each nut-type head uses a bit matched to the arbor size.
5. Replace and tighten the ring.
6. Remove the retaining nut or screw before operating the tool.
We, Sioux Tools Inc., 250 Snap-on Drive, P.O. Box 1596, Murphy, NC, 28906, USA, declare under our sole responsibility that the products
to which this declaration relates are in conformity with the following standard or standards or other normative document or documents:
May 1, 2009
Murphy, North Carolina, USA
Date and place of issues
Form ZCE782
SOUND AND VIBRATION READINGS
*Sound Pressure
Catalog No.
dBA
SCN3R 80.0
SCN5R 80.0
SCN7R 80.0
SCN12R 80.0
SCN20R 80.0
SCN25R 80.0
SCN10S12 80.0
*per PN8NTC1

DECLARATION OF CONFORMITY

EN 792, ISO 12100-1, ISO 12100-2, ISO 8662, Pneurop PN8NTC1
following the provisions of
Vice President and General Manager-Power Tools
Name and position of issuer
*Sound Power
*Vibration m/s
dBA
91.6 Less than 2.5
91.6 Less than 2.5
91.6 Less than 2.5
91.6 Less than 2.5
91.6 Less than 2.5
91.6 Less than 2.5
91.6 Less than 2.5
*per PN8NTC1 *per ISO 8662
SCN SERIES
98/37/EC.
Robert Hartman
Sioux Tools Inc
3
2
Signature of issuer
2013February5/D
Date