Installation Specifications; Planning The Installation - Dacor Heritage HWO127 Instructions D'installation

Planning the Installation

Observe governing codes and ordinances during planning/installa-
tion. Contact your local building department for details.
IMPORTANT
• Place the junction box so the oven may be easily disconnected if it
must be removed for service.
• Ensure the oven is installed fully level, or it may deliver poor/incon-
sistent baking results.
• Ensure the oven is easily accessible. Verify that electrical
power, meeting the specifications on pg. 4, is available to
the intended location.
• Install the junction box as shown on Pgs 5-6.
Cabinet Dimensions
Model (N) Min. Cabinet Width
HWO127 27" (68.6 cm)
HWO130 30" (76.2 cm)
HWO227 27" (68.6 cm)
HWO230 30" (76.2 cm)
Minimum interior cabinet depth: 24" (61.0 cm)
Cutout Dimensions
Single Wall Oven (under-counter install)
4

INSTALLATION SPECIFICATIONS

WARNING
25 5/8" (65.1 cm) min. (recommended) or 26 1/8" (66.4 cm) max.
28 5/8" (72.7 cm) min. (recommended) or 29 1/8" (74.0 cm) max.
25 5/8" (65.1 cm) min. (recommended) or 26 1/8" (66.4 cm) max.
28 5/8" (72.7 cm) min. (recommended) or 29 1/8" (74.0 cm) max.
• Install the junction box so the oven can be removed from the
cutout without being disconnected.
• Plan the installation so all minimum clearances are met or
exceeded. Dimensions shown provide minimum clearances
unless otherwise noted. Ensure proper clearance is provided
for the oven door. (See Product Dimensions.)
• Cabinet cutout dimensions must be followed. The specified
minimum cabinet depth/width must be provided. The cabinet
depth/width must completely enclose the recessed portion of
the oven.
• All contact surfaces between oven and cabinet must be solid
and level.
• Provide a support platform within the cabinet for the oven,
which must be installed level and straight. The top edge of the
platform must be flush with the cutout at the front of the cabi-
net. There is no way to level the oven after installation. 3/4"
(1.9 cm) plywood is recommended.
Cabinet tolerances: +1/16 (1.6 mm), -0, unless otherwise stated
(P) Cutout Width
Cabinet tolerances: +1/16 (1.6 mm), -0, unless otherwise stated
(R) Cutout Height
27" (68.6 cm)
50" (127.0 cm)