Timer Operation - S&P DHUM-12 E Instructions De Montage Et D'utilisation

Room temperature (TºC)
TºC < 5ºC
5ºC < TºC < 20ºC
20ºC < TºC < 27ºC
TºC > 27ºC
• By using the speed selector
Fast Speed: Hi
Slow Speed: Low

Timer operation

By using the button
the end of the programmed period the device stops completely.
During the timer period, the display shows the time programmed, and the indicator
minated, indicating that the device is programmed to function for a limited time period.
Self-defrost cycle
The normal operating temperature range is +5ºC/+32ºC. Operation of the device outside this
range is not recommended.
The self-defrost function is initiated automatically by the device itself. It is activated for a period
of 5 minutes if the ambient temperature is below 15ºC approximately. When this function is
activated, the self-defrost indicator light
Self reset function
The device is equipped with a self reset function. In the event that the power supply is cut
temporarily for any reason, the unit resets itself automatically, retaining the parameters set by
the user before the power cut.
REMOVAL OF WATER
Removal of water by means of the tank
1. An intermittent sound signal accompanied by the illumination of the red light
that the water tank is full. The device will cease to operate until the user empties it (Fig. 3).
2. Once emptied, replace it inside the unit. When the indicator
the tank has been replaced correctly.
Precautions: Do not remove the tank too often. If this action is repeated over a series of short
periods, damage can be caused to the compressor. Wait until the tank is completely full.
, you can set the speed of the fan:
, the user can program a period of operation between 1h and 24h. At
illuminates.
Operating settings
Compressor Stop
60%
55%
50%
goes out, this indicates that
21
is illu-
, indicate