Maintaining Spark Arrestor - Generac GC2200T Manuel De L'utilisateur

General Information and Setup

Maintaining Spark Arrestor

1. See Figure 2-15. Remove screw (A) using a 1/4"
wrench or flat head screwdriver and remove spark
arrestor (B).
A
B
Figure 2-15. Removing Spark Arrestor
NOTE: The amount of carbon particulate will vary with
fuel used, air quality, engine condition and age.
2. Clean spark arrestor screen with a soft non-metal-
lic brush.
3. Inspect screen for any tears, rips, or other damage
which will prevent the screen from operating prop-
erly. Replace the spark arrestor if screen is dam-
aged.
4. Install the new or cleaned/inspected screen with
screw using a 1/4" wrench or nut driver.
10
B
C
A
010593
Owner's Manual for Trimmer/Mower™