Aukey Neckband Mode D'emploi page 8

Simultaneous Pairing with Two Devices
1. Follow the above instructions to pair the earbuds with Device A.
2. Once paired, turn off Bluetooth on Device A and turn off the earbuds.
3. Follow the above "Pairing" section to pair with Device B.
4. Once paired with Device B, reactivate Bluetooth on Device A and select "AUKEY
EP-B33" in the list of paired devices.
5. You can now make and receive calls from either of the two paired devices.
Notes
● To clear the pairing list, power on the headphones and then hold volume + and
volume - simultaneously for 5 sec until the LED indicator lights up green and white in
the same time. Once the pairing list is cleared, you'll hear a tone and the
headphones will automatically enter pairing mode.
● The headphones will automatically shut down after 5 min in standby mode if no
devices are paired.
● If your paired device is turned off or manually disconnected, the LED indicator will
flash white twice every 5 sec and the headphones will shut down after 5 min.
● Double-press the multi-function button to enter pairing mode. The LED indicator will
flash white and green alternately. If no devices are paired in 3 min, the headphones
will enter standby mode.
- 06 -