Symbols On The Chainsaw; Before Use - Casals CS52PA Notice Originale

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.1. SAFETY WARNINGS AND EXPLANATIONS:
]
Read owner's manual before operating this ma-
chine.
Wear head, eye and ear protection.
Use the chainsaw with two hands.
Warning! Kickback is dangerous.
!
Warning/Attention

2.2. SYMBOLS ON THE CHAINSAW

For safe operation and maintenance, symbols are
carved into the moulding of the chainsaw. Accord-
ing to these indications, please be careful not to
make a mistake.
A- Fuel tank - Position: fuel tank cap
B- Oil Tank – Position: oil cap
C- Engine Switch operation. Flipping the engine
switch to the "O" (stop) direction, the engine stops
– Position: rear-left of the unit
D- Choke knob operation. Pulling out the choke
knob, the choke closes- Position: rear-right of the
unit
E- Chain oil adjustment indication- "Min" direction
the oil flow decrease "Max" direction the oil flow
increases –
Position: bottom of the clutch side
F- The position of H needle
The position of L needle
The position of idle adjusting screw
Position: rear left of the unit.
3. COMPONENTS:
1. Guide bar
2. Chain
3. Exhaust muffler
4. Chain break
5. Front handle
6. Throttle switch
7. Pull starter handle
8. Chain lube oil tank
9. Air filter cover
10. Fuel tank
11. Choke knobb
12. Throttle safety switch
13. Rear handle
14. ON/OFF engine switch
4. USE AND CARE:

4.1. BEFORE USE:

4.1.1. Read this owners manual carefully to under-
stand how to operate this unit properly.
4.1.2. You should never use the product when
under the influence of alcohol. When suffering from
exhaustion or lack of sleep, drowsiness as a result
of haven taken cold medicine or at any other time
when a possibility exist that your judgement might
be impaired or that you might not be able to oper-
ate the machine properly and in a safe manner.
4.1.3. Avoid running the engine indoors. The ex-
haust gasses contain harmful carbon monoxide.
4.1.4. Never use the product under the circum-
stances listed below.
•When the ground is slippery or when other
conditions exist which might take it not possible to
maintain a steady posture.
•At night, at times of heavy fog or at any other
times when your field of vision might be limited and
it would be difficult to gain clear view of the area.
•During rain storms, lightning storms and gale-
force or strong winds or at any other times when
weather conditions might make it unsafe to use
this product.
4.1.5. Lack of sleep, tiredness or physical exhaus-
tion results in lower attention spans and this In turn
leads to accidents and injury.
4.1.6. Limit the amount of time of using the
machine continuously to somewhere around 10
minutes per session and take 10- 20 minutes to
rest between work sessions. Also try to keep the

Publicité

Table des Matières
loading

Table des Matières