Facom CL2.C1913D Notice D'instructions page 14

Intended use of the machines :
- The CL2.C1913D screwdrivers and nutrunners are designed to screw and unscrew screws and nuts.
Using the machine:
- Apply the safety instructions provided in this manual.
- Fitting the socket on the nutrunner:
- Engage the socket fully on the drive square (mark 5).
- Check it is maintained properly by pulling it.
- Select the rotation direction (selector mark 2).
- To start, press the trigger (mark 1) gradually.
The variator allows for increasing the rotation speed according to the pressure on the trigger.
For safety reasons, the chuck is stopped when the trigger is released.
- To improve visibility, you can switch on the built-in LED light (button mark 3).
Do not forget to switch off the LED light after use (switch off after 15 min).
Do not change the speed, rotation direction, or screwing torque while the motor is running.
Recommendations of use:
Accessories:
- Only use accessories adapted to the task at hand and to the machine used (impact grade sockets and bits) ; your safety, the quality of your work and the
tools lifetime depend on it.
The FACOM range includes a range of impact bits, bit holders and sockets suited to your needs (see <<FACOM accessories>> section).
Screwing:
These machines are no substitutes for torque wrenches (the max torques are approximate). For high quality screwing, use the machine for the approach
work, and complete tightening by hand or using a torque wrench.
CAUTION ! the machine's power is likely to damage a screw offering insufficient resistance (e.g. wheel nuts...)
Noise and vibration in machine:
Values measured in compliance with the EN 60745 European Standard
The actual value measured for continuous acoustic pressure weighted equivalent A is 76,598 dB (A) for the machine.
The value for acoustic power is 87,59 dB (A) for the machine.
Always use ear protection for any work !
The vibration transmitted in the forearm and the hand is 20,26 m/s
EC STATEMENT OF COMPLIANCE:
WE, FACOM S.A.S., 6/8 RUE GUSTAVE EIFFEL - BP 99 - 91 423 MORANGIS CEDEX FRANCE, STATE UNDER OUR LIABILITY THAT THE FOLLOWING PRODUCTS:
CL2.C1913D – IMPACT WRENCH SET 19,2 VD.C BY FACOM
COMPLY WITH THE PROVISIONS SET OUT IN THE FOLLOWING EUROPEAN DIRECTIVES:
- ''MACHINES'' DIRECTIVE 2006/42/EC
- ''LOW VOLTAGE'' DIRECTIVE 2006/95/EC
- ''EMC'' DIRECTIVE 2004/108/EC
AND COMPLY WITH THE PROVISIONS SET OUT IN THE FOLLOWING HARMONISED EUROPEAN STANDARDS:
- EN 60745
- EN 55014
- EN 60335
for the machine.
2
1
5
2
3
20.01.2010
Manager
The FACOM Quality
14