VALBERG WF 814 S566C Consignes D'utilisation page 15

B
Using the appliance
Temp.
When needed, the washing temperature can be adjusted by pressing the temperature
button in the following steps: Cold - 20°C - 30°C - 40°C - 60°C - 90°C.
Delay
Set the Delay function:
ΠSelect a programme;
 Press the Delay button to choose the time (the delaying time is 0-24 hr.);
Ž Press [Start/Pause] to commence the delay operation
Choose the Programme Setting time
Cancel the Delay function:
Press the [Delay] button until the display be 0H.It should be pressed before starting
the programme. If the programme has already started, you should switch off the
programme to reset a new one.
Soil
The washing time will increase or decrease after you select it.
Pre Wash
The Prewash function can get an extra wash before main wash,it is suitable for
washing the dust rises to surface of the clothes;You need to put detergent into the
Case (I) when select it.
Extra Wash
Use for very dirty clothes. Select it to increase the washing time and intensity for
increased washing effect.
Speed Wash
This function can reduce the washing time.
26
Delay
Start
EN
B
Using the appliance
Extra Rinse
The laundry will undergo an extra rinse when you select it.
My Cycle
To memorise the most frequently used programme.
After choosing the programme and setting the options, press [Temp.] 3 sec. before
start to wash.The default setting course is Cotton.
Anti-Crease
Anti-Crease function can be used to reduce wrinkles in clothes.
Reload
This operation can be executed during the washing process. When the drum is
still rolling and there is a large amount of water at high temperature in the drum.
The status is unsafe and the door cannot be opened forcefully.
Press [Start/Pause] for 3 sec. to reload, and add clothes at the midway point. Please
follow the steps below:
ΠWait until the drum stops rotating.
 The door is unlocked.
Ž Close the door when the clothes are reloaded and press the [Start/Pause] button.
Clothes
Press [Start/Pause] 3 sec. Reload the clothes
Child Lock
To avoid mis-operation by children.
Press [Function] and [Select] 3 sec. until the buzzer is heard.
Function
Select
27
Start
EN