Vimar ELVOX 7200 Manuel Utilisateur page 7

7200
Settings and operating modes
Selecting the speech unit call melody
The monitor has seven different melodies. To select a different
melody from the default one (ding dang dong), when the monitor
is switched off hold down either of the brightness control push-but-
tons ( and
press the buttons repeatedly to select the desired melody.
Adjusting the ringtone volume
To adjust the call ringtone volume, hold down either of the volume
control push-buttons (
seconds, then press the buttons repeatedly to increase, decrease
or mute the ringtone volume.
Ringtone mute
Ringtone mute is activated using the same procedure described
above for adjusting the ringtone volume. Once the volume has
been adjusted to the lowest setting by repeatedly pressing the
down arrow, the red LED
illuminates to indicate that ringtone mute is activated.
Brightness control
Brightness can only be adjusted when the display is switched on.
Use the brightness control push-buttons
EN
) for at least one second, then
and ), for at least two
in the bottom left-hand corner,
(
) to select the brightness. When the maximum and
minimum values are reached, this is indicated by a beep.
Adjusting the conversation volume
The term "conversation volume" refers to the perceived volume of
the caller's voice when he/she is standing in front of the speech
unit (entrance panel). To adjust the conversation volume, hold
down the TALK/LISTEN push-button
decrease the setting using the volume control push-buttons
and
FREE mode and in PUSH-TO-TALK mode.
Communication mode selection function
It is possible to choose one of two different modes of communica-
tion with the speech units:
1) HANDS FREE mode: press the TALK/LISTEN button
at the start of the conversation only, to activate the audio, and
at the end of the conversation to deactivate the audio. The
"audio active" status is indicated by illumination of the red LED
in the bottom left corner of the monitor, which is normal-
ly used to indicate RINGTONE MUTE.
2) PUSH-TO-TALK mode: keep the talk/listen push-button
pressed during the conversation; release it at the end
of the conversation. The 7200 series monitor is factory set to
HANDS FREE communication mode.
and
and increase or
). This procedure applies both in HANDS
(
7