Top View - GE PDW1860K01SS Instructions D'installation

Installation Instructions
STEP 9 POSITION DISHWASHER UNDER
COUNTERTOP
• Push the dishwasher into the cabinet.
• Push the sides with your hands. Do not use your knee
against the door since door damage will occur.
• Check that the tub insulation blanket does not get
"bunched-up" or interfere with the springs as you slide it
into the cabinet.
• Center the dishwasher in the opening.
• Carefully open and close the door to ensure that the door
panel does not catch or rub on the cabinet frame.
• If the door catches or rubs on the frame, reposition and/or
level the unit (see Step 10) until the door moves freely and
does not contact the cabinet frame.
The controls on these models are designed to be hidden by
your countertop. Align the dishwasher as shown in Figure
Q. Leave a 1/2" minimum gap between the underside of the
countertop and the top of the dishwasher door as shown in
Figure T.
Note: If the drain hose gets trapped behind the unit it can
prevent the controls from being hidden by the countertop.
Note: If this dishwasher is replacing an existing dishwasher,
the old countertop bracket screw holes may not be in the
correct position to accept a top-control model. New holes may
be required.
Tip: The leveling legs can be used to increase or decrease
the amount of gap between the controls and the countertop
affecting the visibility of the controls.
IMPORTANT
– Leave a 1/2" minimum gap between
the controls and the underside of the countertop to prevent
condensation and damage to the control panel from
screwheads.
8
Figure P
Figure Q
Top View
ON DELAY
START
OFF
1 - 24 HRS.
Controls Hidden
by Countertop
Figure R
Countertop
Control
Panel
Figure S
LOW RINSE AID
Countertop
1/2"
Min.
Dishwasher
Door
Figure T