GE PDW1860K01SS Instructions D'installation page 6

Installation Instructions
STEP 2 ADJUST LEVELING LEGS
• Move the dishwasher close to the installation location and
lay it on its back.
Adjust to
Installation
Height
Figure I
• Measure installation height and dishwasher height. Extend
leveling legs out from the dishwasher base, 1/2" less than
installation height.
STEP 3 REMOVE TOEKICK
Remove
4 Toekick
Screws
Figure J
6
STEP 4 INSTALL POWER CORD
Skip this step if dishwasher will be direct wired.
Use Power Cord Kit WX09X70910, available for purchase
from an authorized GE Appliance Dealer. The power cord and
connections must comply with the National Electrical Code,
Section 422 and/or local codes and ordinances.
• Maximum power cord length is 6'.
A B
Remove
Green Dishwasher Wires Are Threaded
Junction Box
Cover
Ground
D
Use UL Listed
Wire Nuts
Figure K
• Connect incoming power cord white (or ribbed) to
dishwasher white, black (or smooth) to black and ground to
dishwasher green wire. Use UL listed wire nuts of appropriate
size.
• Replace junction box cover. Be sure wires are not pinched
under the cover.
STEP 5 INSTALL 90° ELBOW
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
°
90
Elbow
Thread
Seal Tape
Figure L
• Do not over tighten 90° elbow, water valve bracket could
• Position the end of the elbow to face the rear of the
dishwasher.
Check That White, Black and
Thru Hole in Back
White
Black
C
Insert Power
Cord Wires Thru
Strain Relief
and Tighten
Fill
Hose
Water
Valve
Bracket