Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Conneting rods for guide rails
1.
To connect both guide rails slide the rst connecting rod from the bottom into
the groove of the guide rail.
2.
Slide the other connecting rod into the second groove.
3.
Use the 3 mm Allen key to tighten the stud screws to the limit stop to connect
the rails.
The parallel guide
To cut parallel to a wood edge, you can use the enclosed parallel guide (22).
1.
1. In order to x the parallel guide (22), loosen the clamping knob (10) slightly.
Using the centimetre scale on the parallel stop, you can adjust the distance
between the stop bar and the saw blade.
2.
2. Secure the parallel guide by tightening the clamping knob (10). When not
using the parallel guide, tighten the clamping knob (10) securely. The clam-
ping knob can be unscrewed and fall o due to the vibration of sawing.
Saw blade
NOTE:
•
Use only saw blades with diameters in accordance with the requirements on
the saw.
•
Use only recommended saw blades.
180321_ayce_Multi-Tauchsäge_IM_rz.indd 88
21.03.18 13:31
Publicité
Table des Matières
