Ayce M1Y-KZ-125 Manuel D'utilisation page 85

WARNING: An unprotected, coasting bladewill cause the saw to walk backwards,
cutting whatever is in its path. Be aware of the time it takes for the balde to stop
after switch is released.
ON/OFF swtich
1. Press the ON/OFF switch (2) to switch the plunge saw on.
2. Release the ON/OFF switch (2) to switch the plunge saw o.
3. Pressing the locking switch (1) unlocks the plunge cut mechanism, so that the
motor can be moved downwards. The saw blade emerges from the protective
cover. When lifting the saw, the motor slides back into the initial position.
Set cutting depth
The cutting depth can be set between 0 – 42 mm:
1. Loosen the cutting depth limit stop knob (5) and slide it to the desired cutting
depth according to the graduated scale (12) to set the cutting depth.
2. Tighten the cutting depth limit stop knob (5). The motor or respectively the
saw blade can now be pushed down to the set cutting depth. For a clean, safe
cut set the cutting depth in such way that only max. one saw blade tooth pro-
trudes under the work piece.
Determine cutting line
The cutting line (9) is marked on the base plate (6) of the plunge saw. Align cutting
line (9) at the front and back of the base plate with your marked cutting line when
using the plunge saw without guide rail for straight cuts.
Laser function
You can switch the laser ON and OFF with the switch (19). The laser directs a beam
onto the work-piece. Extremely precise cuts can be made using the laser function.
180321_ayce_Multi-Tauchsäge_IM_rz.indd 85
84 85
21.03.18 13:31