Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Operation of the appliance
Preparation
NOTE:
•
Before each use check the proper function of all installation fi xtures of the
plunge saw and only use the plunge saw if everything works properly.
•
Attach the work piece in such way that it cannot move or bend during work.
Line the work piece respectively.
Correct working with the plunge
•
Always hold the plunge saw with both hands at the hand grips (3) and (13).
•
Always guide the plunge saw forward. Never draw the plunge saw back!
•
Place the plunge saw with the front part of the base plate (6) on the work pie-
ce. Guide the plunge saw only against the work piece during operation.
•
With the correct forward speed you prevent overheating of the saw blade, and
melting when cutting plastics.
Straight cuts
1.
Set the desired plunge depth.
2.
To switch on the saw press the ON/OFF switch (2). Press the locking switch (1)
and push the motor down. Guide the saw forward to cut.
Plunge cuts
1.
Set the desired plunge depth.
2.
To switch on the saw press the ON/OFF switch (2). Press the locking switch (1)
and push the motor down. Guide the saw forward to cut.
Note: To prevent the saw from kicking back during plunge cuts follow these steps:
•
Always place the plunge saw with the rear edge of the base plate (6) against a
xed limit stop.
•
Hold the plunge saw in both hands and slowly lower the saw blade.
180321_ayce_Multi-Tauchsäge_IM_rz.indd 86
21.03.18 13:31
Publicité
Table des Matières
