Lighting Features; Water Temperature; Rinse Agent; Dish Preparation Prior To Loading - GE MONOGRAM ZDT975SSJSS Mode D'emploi

Interior Lights
Lighting
Features
The interior LED lights provide better visibility for
loading and unloading. Do not look directly into
the LED lights. They turn on when the door is
opened and turn off when the door is closed.
The lights will turn off after 15 minutes if the door
remains open. To turn the lights back on, close
and open the door.
Water
The entering water must be at least 120°F (49°C)
and not more than 150°F (66°C), for effective
Temperature
cleaning and to prevent dish damage.
Recommended
GE recommends the following products for use in
its dishwashers:
Dishwasher
Products
• For your manual detergent dispenser, Cascade®
Platinum Pacs are recommended. Powders,
liquids, and gels may also be used but may not
work as effectively.
Rinse agents, such as Cascade
Use a Rinse
designed for great drying action and to protect
Agent
against spots and film build-up on your dishes,
glasses, flatware, cookware, and plastic.
Filling the Dispenser
The rinse agent dispenser holds 3.5 oz. (104 ml) of
rinse agent. Under normal conditions, this will last
approximately one month - depending on setting.
1
2
3
4
5
10
Make sure the dishwasher door is fully open.
Open the Rinse Agent dispenser door.
Slowly add rinse agent until the cup is full. You may
need to pause several times to allow rinse aid to
settle.
Clean up any spilled rinse agent with a damp cloth to
prevent foam from forming inside the dishwasher.
Close the Rinse Agent dispenser door.
Using the Dishwasher
Do not attempt to replace the lights. If light
replacement is necessary, please contact the
GE Answer Center for service by calling
1.800.626.2000.
Check the water temperature with a candy or
meat thermometer. Turn on the hot water faucet
nearest the dishwasher, place the thermometer
in a glass and let the water run continuously into
the glass until the temperature stops rising.
• For your rinse agent dispenser, Cascade®
Rinse Aid.
Rinse Aid are Rinse Aid Setting
®
The amount of rinse agent released into the final
wash can be adjusted. If water drops or hard water
spots remain on dishes after the dry cycle, increase
the setting.
To adjust the setting
Open the Rinse Agent dispenser door; then turn
the adjuster clockwise to increase the amount of
rinse agent, counterclockwise to reduce the amount
of rinse agent.
Dishwasher
Rinse
agent
adjuster
Clockwise to reduce Counterclockwise
water drops and to reduce foaming
hard water spots