Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Directly above or below
8.
beam (Figure
).
E 3
Measure the distance between
9.
If your measurement is greater than the Allowable
10.
Distance Between
ing Distance Between Walls in the following table,
the laser must be serviced at an authorized service
center.
Distance
Between Walls
30'
40'
50'
Distance
Between Walls
9.0 m
12.0 m
15.0 m
Vertical Beam
Checking the vertical (plumb) calibration of the
laser can be most accurately done when there is a
substantial amount of vertical height available, ideally
30' (9m), with one person on the floor positioning
the laser and another person near a ceiling to mark
the position of the beam. It is important to conduct a
calibration check using a distance no shorter than the
distance of the applications for which the tool will be
used.
Place the laser on a smooth, flat, stable surface
1.
that is level in both directions (Figure
Move the Power/Transport Lock switch to the right
2.
to turn the laser ON.
Press
and
to turn on both vertical beams.
3.
Mark two short lines where the beams cross
4.
,
and also on the ceiling
a
b
the center of the beam's thickness (Figure
, mark
along the laser
a
c
and
.
a
c
and
for the correspond-
c
a
Allowable Distance
Between
and
c
a
1/4"
5/16"
13/32"
Allowable Distance
Between
and
a
c
6.2 mm
8.3 mm
10.4 mm
).
F 1
,
. Always mark
c
d
F 2
Pick up and rotate the laser 180º, and position it
5.
so the beams line up with the marked lines on the
level surface (
e
Mark two short lines where the beams cross on the
6.
ceiling
,
.
g
h
Measure the distance between each set of marked
7.
lines on the ceiling (
surement is greater than the values shown below,
the laser must be serviced at an authorized service
center.
Ceiling Height
8'
10'
14'
18'
30'
Ceiling Height
2.5 m
3.0 m
4.0 m
6.0 m
9.0 m
90º Accuracy Between Vertical Beams
Checking 90º accuracy requires an open floor area at
least 33' x 18' (10m x 5m). Refer to Figure
position of the laser at each step and for the location of
the marks made at each step. Always mark the center
of the beam's thickness.
Place the laser on a smooth, flat, stable surface
1.
that is level in both directions.
Move the Power/Transport Lock switch to the right
2.
to turn the laser ON.
Press
to turn on the side vertical beam.
3.
).
,
) (Figure
).
f
F 3
,
and
,
). If the mea-
g
c
d
h
Allowable Distance
Between Marks
1/16"
3/32"
1/8"
5/32'
1/4'
Allowable Distance
Between Marks
1.7 mm
2.1 mm
2.8 mm
4.1 mm
6.2 mm
G
E
for the
17
Publicité
Table des Matières
