Changing The Light Bulb(S); Power Interruptions; Moving Care; Troubleshooting - Amana AZF33X16DW Mode D'emploi

Changing the Light Bulb(s)

IMPORTANT: The lighting system in this appliance may consist
of:
Sealed LED modules
■
LED Bulbs
■
Incandescent Bulbs
■
Sealed LED module is an LED which does not need to be
replaced. If a Sealed LED module(s) do not illuminate when the
refrigerator and/or freezer door is opened, call for assistance or
service. See "Warranty" for contact information.
If a LED Bulb does not illuminate when the refrigerator and/
or freezer door is opened, replace with like bulb following this
procedure:
1. Unplug the appliance or disconnect power.
2. Remove the light shield.
Remove the hardware holding the light shield in place.
■
Top of the appliance compartment - Slide the light shield
■
toward the back of the compartment to release it from the
light assembly.
3. Replace the burned-out bulb(s) with a LED bulb of the same
size, shape and wattage.
Order Part Number W10805744 (3.6 W).
■
NOTE: Some LED replacement bulbs are not recommended
for wet/damp environments. The refrigerator and freezer
compartments are considered to be wet/damp environments.
If using a brand of LED bulb other than the recommended
LED bulb, before installation, read and follow all instructions
on the LED packaging.
4. Replace the light shield by inserting the tabs on the shield
into the liner holes on each side of the light assembly. Slide
the shield toward the front until it locks into place.
NOTE: To avoid damaging the light shield, do not force the
shield beyond the locking Point.
5. Replace the hardware that holds the shield in place.
6. Plug in the appliance or reconnect power.
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call,
refer to the warranty page in this manual, or visit http://amana.custhelp.com. In Canada, visit www.amanacanada.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Amana Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
If an incandescent bulb does not illuminate when the refrigerator
and/or freezer door is opened, replace with like bulb using the
same procedure outlined above. Replace burned out bulb with
only incandescent bulb(s) of the same size, shape and wattage
(maximum 40 W) designed for household appliances.

Power Interruptions

If the power will be out for 24 hours or less, keep the door closed
to help food stay cold and frozen.
If the power will be out for more than 24 hours, do one of the
following:
Remove all frozen food and store it in a frozen food locker.
■
If a food locker is not available, consume or can perishable
■
food at once.
REMEMBER: A full freezer stays cold longer than a partially filled
one. A freezer full of meat stays cold longer than a freezer full of
baked goods. If you see that food contains ice crystals, it may be
refrozen, although the quality and flavor may be affected. If the
condition of the food is poor, dispose of it.

Moving Care

When you are moving your freezer to a new home, follow these
steps to prepare it for the move.
1. Remove all frozen food.
2. Unplug the freezer.
3. Take out all removable parts, wrap them well, and tape them
together so they don't shift and rattle during the move.
4. Clean the freezer thoroughly.
5. Tape the freezer shut and tape the electrical cord to the
cabinet.
When you get to your new home, refer to the "Installing Your
Freezer" and "Operating Your Freezer" sections for information
on installation and setting the controls.

TROUBLESHOOTING

In Canada:
Amana Brand Home Appliances
Customer eXperience Centre
200 – 6750 Century Ave.
Mississauga, Ontario L5N 0B7
10