Roto ZRV E 6 Instructions De Montage page 8

English
Some installation steps differentiate between wooden
and plastic windows:
• Figures labelled with "...K" next to the figure number
apply to plastic windows.
• Figures labelled with "...H" next to the figure number
apply to wooden windows.
• Figures labelled with "WDT" next to the figure number
apply to WDT windows.
• Figures labelled with "WDC" next to the figure number
apply to WDC windows.
• Figures without a label next to the figure number apply
to all types.
Installation
(Fig. 1-19 WDF + Fig. 1-8 WDT/WDC)
⚠
Danger to life and limb due to damaged
power cables!
Damaged power cables can lead to severe
electric shocks and fires.
> During the entire installation procedure, make sure
that the power cable is not jammed, drilled into,
or damaged.
⚠
Risk of falling!
The window is open during part of the instal-
lation process.
> Do not lean out of the skylight.
> Ensure that you have a secure hold.
> Only use climbing equipment that is resting on a
solid foundation and that offers good support and
high carrying capacity.
> When working at great heights, the appropriate
provisions must be made to protect against falling.
> Never grab onto the blackout blind.
⚠
Risk of crushing and other injuries from tilt-
ing skylight!
> Secure the window to avoid unintentional tilting
(see skylight operating instructions).
> Keep hands away from the window frame during
tilting.
⚠
Risk of injury from falling components!
> To mount the product, only use fixing materials
that were included in the delivery and that are
suitable for the window frame material.
> Never place tools, components and fixing materials
on the climbing equipment.
> Keep children away from the installation site
throughout the installation procedure.
8
⚠
Risk of falling due to being startled!
An electrostatic discharge and a loud noise
(popping, crackling) may occur when the
blackout blind is touched with a hand or
object.
> Ensure that you have secure footing.
On-site connection
(Fig. 13 WDF+18 WDF+8 WDT/WDC)
⚠
Danger to life and limb due to incorrect con-
nection of the electrical components!
> The on-site connection of the blackout blind to a
control system and electrical power source must
be performed by a certified electrician in accord-
ance with the electrical installation regulations
published by the Association of German Electrical
Engineers (VDE 100) or the standards and regula-
tions of the country in which the device is being
installed.
> Only connect the blackout blind if the power
source matches the specifications on the type la-
bel.
• See the installation instructions of the control system
("ZEL STG...") for safety instructions, instructions for
on-site connection, and the connection diagram.
Settings
(no figure)
Settings are not required after installation.
Operation
(no figure)
• Only operate with the window closed.
• Operation depends on the selected control system.
• See the manual of the control system ("ZEL STG...")
for safety instructions and instructions for operation.
⚠
Risk of crushing and injury!
> Keep the extension/retraction area clear of fixed
and moving obstacles.
> When extending/retracting the product, do not
reach into movable parts and do not pull on the
blackout blind.