Using The Receiver - Stanley FATMAX FMHT1-77360 Manuel Utilisateur

GB
User Manual
Equipment Setup
A
Excavation
Depth
Set up laser in a suitable location where it will be visible to the receiver, but clear of danger and vibrations. (≥10m to
≤200m)
(See figure A )
Determine the distance from the height of the laser to the bottom of the excavation (L).
Place the receiver on the arm of the excavator that matches the distance, L.
When measuring L on arm of excavator, confirm arm is fairly plumb and bucket is oriented correctly.
Mounting Receiver
With Magnets (See figure B )
The receiver attaches directly to the excavator arm. Because the magnets are so strong, it is recommended to hold the
receiver at an angle to the steel surface to allow for adjustment before making full contact with the surface.
Optional Mounting: With Clamps(See figure C )
(2) Clamps can be used to attach the receiver onto square or round tubes or bars ranging from 1 5/8" to 2 1/8" o.d.
(40-55mm).

Using the Receiver

ON- Press the Power button momentarily to turn on the unit. The LEDs will blink momentarily to indicate Fine or
Coarse accuracy setting. (The last setting used is stored into memory and becomes the default setting.
Coarse
OFF- Press and hold the Power button >3 seconds to turn off the unit.
MENU- To access the settings menu, the receiver must be off. Press and hold the power button on receiver until the
top two LEDs are alternately flashing. Release the power button when your menu choice is lit. Accuracy is top LED.
Channel is 2nd LED.
Accuracy
4
L
Yellow
Yellow
Fine Green
Red
Red
Yellow
Yellow
Channel
Green
Red
Red
B
Bucket
L
Extended