Declaration Of Conformity - Stanley FATMAX FMHT1-77360 Manuel Utilisateur

Power & Recharging (Receiver)
The receiver has a NiMh rechargeable battery which can provide up to 30 hrs of use. The 110V/240V charger which
is included can recharge the battery in 12 hours. The battery indicator LED will light during charging and when the
battery is low.
• For best life, the rechargeable battery must be charged for 12 hours before first use.
1. Unscrew Battery charging port cover
2. Connect 3.5mm jack to port
3. Connect power adapter to AC outlet
Battery indicator will light when the battery is low.
NOTE: Charge/discharge the battery a few times to reach full capacity.
WARNING!
Use charging / power adapter only with Ni-MH battery pack supplied.
Charging any other type of battery may result in damage and/or personal harm.
WARNING!
The battery and charging / power adapter can be damaged if damp. Always store and charge the tool in a dry
and covered place.
End of Life
DO NOT dispose of this product with household waste.
ALWAYS dispose of batteries per local code.
PLEASE RECYCLE in line with local provisions for the collection and disposal of electrical and electronic waste under
the WEEE Directive.

Declaration of Conformity

Stanley Tools declares that the CE Mark has been applied to this product in accordance with the CE Marking Directive
93/68/EEC.
For further details please refer to www.stanleytools.com.
ROHS Compliant
Description
The Receiver- Used with or without the remote display, it provides accurate feedback about grade information for
machine control applications. Using the provided magnets, mount the receiver to the excavator arm of the equipment.
It has two modes of accuracy, fine and coarse, to provide the best results for your particular job. Coarse mode has
7 indication stages of level. In fine mode, there are 9 indicators.
A plumb indicator monitors the angle of the excavator arm, signaling under- or over-extension. This assures consistent,
accurate grade readings.
The Remote Display- Wireless linking of the receiver to a remote display eliminates any hard-wired connection. So it
can mount in the cab of the vehicle using a suction cup mount.
Power for the display is provided via a car power adapter.
3