Important - IKEA TRADFRI Démarrage Rapide

English
WIRELESS SIGNAL REPEATER
FUNCTIONS
With TRÅDFRI signal repeater you can
expand the signal reach of your IKEA
Home smart products.
Pairing: Add IKEA Home smart
products to your system. See
instructions below.
ADDING STEERING DEVICE TO
YOUR SIGNAL REPEATER
When the Signal Repeater is sold
together with another IKEA Home smart
product (in the same package), they are
already paired.
You cannot add IKEA Home smart
products directly to your signal
repeater. A TRÅDFRI steering device is
needed to add them.
To add steering devices, just follow the
steps below:
Make sure that your signal repeater
is plugged in and the main power is
turned on.
1. Hold the steering device close to the
signal repeater you want to add (no
more than 5 cm away).
2. Press and hold the pairing button for
at least 10 seconds , you can find the
pairing button under the rear cover.
3. A red light will shine steadily on the
steering device.
Then go to the product you want to
steer and then repeat the pairing.
On your IKEA Home smart products a
white light will begin to dim and flash
one time to indicate that it has been
successfully paired.
FACTORY RESET YOUR DEVICE
For wireless signal repeater:
Push a pin into the pinhole on bottom
of the signal repeater for at least 5
seconds.
After reset the signal repeater you must
pair your steering device to the signal
repeater and then pair the steering
device to your IKEA Home smart product
product again.

IMPORTANT!

• The Signal Repeater is for indoor use
only and can be used in temperatures
ranging from 0ºC to 40 ºC
(32ºF to 104 ºF).
• Do not leave the wireless Signal
Repeater in direct sunlight or near any
heat source, as it may overheat.
• The range between the wireless
Signal Repeater and the receiver
are measured in open air. Different
building materials and placement
of the units can affect the wireless
connectivity range.
4