Base Assembly Instructions - Champion SKYBIRD TRAP Manuel De L'opérateur

USE THE FOLLOWING INSTRUCTIONS TO ASSEMBLE THE TRAP BASE
NOTE: YOU WILL NEED TWO (2) 10MM WRENCHES AND TWO (2) 17MM WRENCHES TO ASSEMBLE THE TRAP
STAND
(Included wrench (P) is 17MM on one end. 10MM wrench not included. Adjustable wrenches may also be used.)
1. ATTACH THE FRONT LEG (C) TO THE BASE LEG (D) USING TWO (2) 10MM X 20MM BOLTS (N-5) AND TWO
(2) 10MM NYLOC HEX NUTS (N-6).
2. MOUNT THE FOOT RELEASE (E) TO THE BASE LEG (D) USING TWO (2) 6MM x 20MM BOLTS (N-3) AND
TWO (2) 6MM NYLOC HEX NUTS (N-4).
3. MAKE SURE ALL FASTENERS ARE SECURELY ATTACHED AND TIGHTENED.
REFER TO THE FOLLOWING SECTIONS FOR TRAP ASSEMBLY AND MOUNTING INSTRUCTIONS

BASE ASSEMBLY INSTRUCTIONS

FIGURE 1
4