Briteq LD SMART DIM Mode D'emploi page 4

ENGLISH
This symbol means: Safety Class III appliance
This symbol means: Lamp Control Gear
 To prevent fire or shock hazard, do not expose this appliance to rain or moisture.
 To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when
bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full
performance or may even cause damages.
 This unit is for indoor use only.
 Don't place metal objects or spill liquid inside the unit. No objects filled with liquids, such as vases, shall be
placed on this appliance. Electric shock or malfunction may result. If a foreign object enters the unit,
immediately disconnect the mains power.
 No naked flame sources, such as lighted candles, should be placed on the appliance.
 Prevent use in dusty environments and clean the unit regularly.
 Keep the unit away from children.
 Inexperienced persons should not operate this device.
 Maximum save ambient temperature is 40°C. Don't use this unit at higher ambient temperatures.
 The electrical installation should be carried out by qualified personal only, according to the regulations for
electrical and mechanical safety in your country.
 Check that the available voltage is not higher than the one stated on the rear panel of the unit.
 In order to prevent electric shock, do not open the cover.
 In the event of serious operating problems, stop using the appliance and contact your dealer immediately.
 Please use the original packing when the device is to be transported.
 Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
MAINTENANCE
Clean by wiping with a polished cloth slightly dipped with water. Avoid getting water inside the unit. Do not
use volatile liquids such as benzene or thinner which will damage the unit.
FUNCTIONS
1. Mode button: The mode button allows the user to toggle thru the different functions such as dimmer,
color, fade and scene.
2. MODE LEDs: those LEDs allow the user to see in which mode the controller is, for example: dimmer,
color, fade or scene.
3. Jog wheel: The jog wheel allows the user to change the value of the selected function like the dimmer,
color,... Push on the jog wheel to switch ON/OFF the light. Push for 5s on the jog wheel to switch ON the
service light mode.
4. Sequence button: This button allows the user to playback a sequence with one or several previously
recorded scenes.
5. Zone button: Those buttons allow the user to select one or several zone to modify the parameter such
as the dimmer, color,... While the unit is in SCENE-mode, these buttons are used to select a scene.
BRITEQ
®
(FRONT)
2/44
OPERATION MANUAL
LD-SMART DIM