ARENDO MILKSKY Manuel D'utilisation page 20

• Take the milk frother from the base unit and pour in milk. Fill the container
only with that much milk, so that at least the minimal (MIN) level is reached.
However, do not fill it with too much milk above the maximum marks (MAX).
Otherwise the device may overflow.
20
Only pour as much milk into the container that it is
filled to just below the desired mark (see the maxi-
mum levels on the previous page as a reference).
Press the button to turn on the
unit:
• Frothing & heating: The LED
indicators lights up by pressing
the start button once. After
completion of the operation, the
red indicator light flashes for 30
seconds.
• Cold milk froth: Pour cold milk
into the case and press and hold
the start button for approxi-
mately 3 seconds, whereupon
the blue LED indicator lights up.
After approximately ~100 sec-
onds, the operation is complete.
The blue LED indicator lights off
and flashes for 30 seconds.
English