asalvo L-FIX Manuel D'instructions page 26

EN
INSTRUCTIONS
5
REMOVING 5-POINT HARNESS
Step1: Removing Shoulder Pads
and Belts Loosen the 5-point
harness of the child seat as
much as possible, remove
the belt from the harness
connector(Picturen A). Take the
Gears
fixed axle from the plastic
stator(Pictures B).
Finally put redundant belt into cloth
cover.(Picture C-Pagel6).
Step2: Removing Buckle
Pull down buckle to clot, and
vertically push our iron plate from
the back of seat(Picture D -Pag 16
) , then remove buckle.
6
REMOVING THE FABRIC COVER
1. Remove the 5-point harness.
2. Take off the cover from the backrest and base.
3. Move the headrest of the child seat up to the highest position.
4. First take the cover off the base of the headrest, then remove the
cover of the headrest.
To re-fit the cover, simply follow the above steps in reverse.
CAUTION! Never use the child seat without a correctly installed buckle.
Make sure that the metal plate is correctly attached.
CAUTION! Check that the harness straps are not twisted and that they
have been correctly inserted in the belt slots of the cover.